• Precautions for printing in cold environments

  When the ambient temperature is lower than 20 ℃ / 68℉, it is recommended that most RESIONE resins, except WW123 and C01 resins, preheat (60-70 ℃ / 140-158℉, 10 minutes) before printing. If the printer is equipped with a heater, preheat for at least 30 minutes to ensure that the resin fluidity is good before printing. In addition, it is recommended to adjust the printing parameters (increase the "bottom lift distance" and "lifting distance",  "Rest Time After Retract/Wait Before Print/Off Time(s)") to cope with the printing failure caused by the increase of resin viscosity.

Settings – Online Form

Download settings files that can be imported into slicers

• All resin (except CL-TH resin) Settings of Chitubox V2 and later

• CL-TH resin Settings of Chitubox V2 and later

How to import a settings file into ChituBox slicer:

Click here to download the guidelines

• D01S resin - Some dental printer's printing settings （ASIGA/Halot Sky 2022/Phrozen sonic 2022/Phrozen XL 2022/Shining 3D Accufab-L4D /UNIZ NEBEE）

• Printing settings for Resione resin of the HeyGears printer

• CL-TH resin Settings of Lychee/HALOT BOX

• Supports Settings For Flexible/Elastic Resin

How do I import supports settings files to CHITUBOX Slicer?

Download settings files here

Import the downloaded files to the CHITUBOX slicer as shown in the following figure